Uniquely patterned sheer organdy defines our Lagoon Specialty Panels & Pillows.  This collection will complement your décor with distinctive style and sophistication in colors Cement, Ivory or Seedpearl.

For tips on how to measure your windows, check out the Diagrams tab. See the Description tab for more information.

Fabric swatches are not available. Panels and pillows are imported. 

  • Products
  • Description
  • Diagrams
  • Related Products

Lagoon Specialty Panels & Pillows

Specialty Panels & Specialty Pillows

    Color

    Options

SP0087
$80.00-$210.00
My Cart Your cart is empty.

Lagoon Specialty Panels & Pillows

Specialty Panels:

  • Lengths: 96” | 108”
  • Single Panel Width: 50”
  • All panels are fashioned with a 4” rod pocket, a 2” header, and back-tabs. The rod-pocket is perfect for gathering the panels on a decorative pole. To create a pleated look, simply run the decorative pole through the back-tabs.
  • Panels are sold singly.
  • Fabric Content: Cotton Organdy (sheer fabric)
  • Panels are unlined.
  • Rod Options: A decorative pole will enhance the beauty of your new Specialty Panels.
  • Size Calculations: (Refer to the Diagrams tab for complete instructions on How to Measure a Window.) Panel “fullness” is the width of the panel relative to the width of the window, door or rod. An easy rule-of-thumb for calculating the amount of panels needed is to use 2X fullness. For example: 100” wide (window) X 2 (fullness) ÷ 50” (single panel width) = 4 single panels.

 

Specialty Pillows:

  • Size: 20” x 20”
  • Pillow Insert: Feather/Down
  • Closure: Concealed zipper
  • Fabric Content: Front side is lined Cotton Organdy (sheer fabric) | Reverse side is Plain Burlap fabric
  • Trim Style: Knife-edge, no trim

How to Measure a Window

Measure windows with a steel measuring tape. Measure all windows in the room, even if they appear to be the same size.

Determine rod placement (options):

  • Distance out past window -- 4” each side is a good rule of thumb
  • Distance out past window -- abut against outside edges of window frame
  • Top of window frame -- corner to corner
  • Wall to wall
     

Determine drapery hardware to be used:

  • Determine how far above window to place hardware -- 4” above frame is a good rule of thumb
  • Determine return size needed (the distance that the rod projects from the wall/window frame


Measure for drapery length:

  • Apron length
  • Floor length
  • Ceiling to floor
  • Allow for floor clearance -- floor length draperies should end 1/2” above floor or just short of the carpet
  • Hint: Place a thin piece of cardboard on top of the carpet to help measure evenly.